Safety - SOLTRON V-60 Shuttle Turbo Plus Gebrauchsanweisung

Please read and observe ...

Safety

Danger!
Assembly and electrical connection must comply with the
1)
national regulations.
The electrical installation is to be fitted with an easily acces-
sible all pole isolating device (master switch) on the building
side, complying with overvoltage category III. This means
that each pin shall have a contact opening width complying
with the conditions of overvoltage category III for full isola-
tion.
If it is connected via a plug and socket, the plug system
used shall comply with EN 60309-1/A11; 5-pin; 400 V AC ~
(25 A) shall be used.
Assembly, installation, upgrading or repair of the device
may only be carried out by specially trained and instructed
personnel.
All danger and safety notes attached to the device must be
observed!
• All danger and safety notes attached to the device must be observed!
• No safety equipment (e.g. panel switch) or safety notes may be re-
moved or deactivated which can impair the safe operation of the de-
vice!
• The device may only be operated in proper condition!
1) In Germany: VDE regulations
• A timing device must be designed so that the device is automatically
switched off at the latest after 110% of the selected operating time
even when the controller fails. The device operating time must be
dual controlled with a timing device to the standards EN 60335-2-27
and A1 2000 Section 22.108 and 22.109.
• Do not change, obstruct or block the air inflow and outflow area to the
device or make any unauthorised changes to the device. The manu-
facturer shall bear no liability for damage or injuries resulting from
such actions.
• Before putting a tanning device into operation, the transport pallet
must be removed from under the device. Danger of overheating by
obstruction of the air routing.
Caution!
The code for access via the infrared interface is preset in
the software of the hand-held unit, and can therefore be
used with any unit. Anyone, who downloads the software
from the Internet can access the unit date with a hand-held
unit. Please note that Customer Service changes the preset
access code during initial start-up – see Page 79. Please
note the new code for future use!
This code is independent of the access code for the preset-
tings via the control panel.
33