Unloading The Dishwasher - Electrolux ESF 66710 Benutzerinformation

Setting and starting the programme with
delay start
1. Once selected the washing programme,
press the delay start button until the flash-
ing number of hours for the delay start
appear in the digital display. The start of
the selected washing programme can be
delayed for between 1 and 19 hours.
2. Close the dishwasher door, the count-
down starts automatically. The number in
the display is no longer flashing but fixed
with static light.
With the delay start function set, the
programme in progress indicator light
goes off. Once the countdown of the de-
lay start has elapsed, the washing pro-
gramme will start automatically and the
programme in progress indicator light
comes on.
3. The countdown will decrease with steps
of 1 hour.
4. The opening of the door will interrupt the
countdown. Close the door; the count-
down will continue from the point at
which it was interrupted.
5. Once the delay start has elapsed the pro-
gramme will start automatically.
The selection of the washing pro-
gramme and delay start can also occur
with the door closed. Keep in mind that
in this way, once a washing programme
button is pressed you have ONLY 3
seconds in which you can choose an-
other programme or select a delay start,
after which the selected programme will
start automatically.
Warning! Interrupt or cancel a
washing programme in progress
ONLY if it's absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.

Unloading the dishwasher

• Hot dishes are sensitive to knocks. The
dishes should therefore be allowed to cool
down before removing from the appliance.
• Empty the lower basket first and then the
upper one; this will avoid water dripping
from the upper basket onto the dishes in
the lower one.
Interrupt a washing programme in
progress
• Open the dishwasher door; the pro-
gramme will stop. Close the door; the pro-
gramme will start from the point at which
it was interrupted.
• Press the On/Off, all indicator lights will go
off. Press the On/Off button again; the pro-
gramme will start from the point at which
it was interrupted.
Cancel a delay start or a washing
programme in progress
• Simultaneously press and hold the two
function buttons B and C until all the pro-
gramme lights come on and the pro-
gramme in progress indicator light goes
off.
• Cancelling a delay start will also cancel the
washing programme. You have to select
the washing programme again.
• If a new washing programme is to be se-
lected, check that there is detergent in the
detergent dispenser.
End of the washing programme
• The dishwasher stops automatically.
• Zero appears in the digital display.
• The programme in progress indicator
light remains on.
• The light of the programme just ended re-
mains on.
1. Switch off the dishwasher by pressing the
On/Off button.
2. Open the dishwasher door, leave it ajar
and wait a few minutes before removing
the dishes; this way they will be cooler
and the drying will be improved.
• Water may appear on the sides and the
door of the dishwasher as the stainless
steel will eventually become cooler than
the dishes.
electrolux 87