First Use; Set The Water Softener - Electrolux ESF 66710 Benutzerinformation

Rinse aid
1)
1) The salt and rinse aid indicator lights never come on while a washing programme is running even if
filling with salt and/or rinse aid is necessary.
The digital display
The digital display indicates:
• the level of hardness to which the water
softener is set,
• the approximate remaining time of the run-
ning programme,
• activation/deactivation of the rinse aid dis-
penser (ONLY with 'Multitab function' ac-
tive),
• the end of a washing programme (a zero
will appear in the digital display),
• the countdown for the delay start,
• fault codes concerning malfunction of the
dishwasher.
Function buttons
The following functions can be set using
these buttons:
• setting the water softener level,
• cancelling a washing programme or a de-
lay start in progress,
• activation/deactivation of the Multitab
function,
• activation/deactivation of the rinse aid dis-
penser when Multitab function is active.
Setting mode
Press the On/Off button. ALL programme
button lights come on. Programme in pro-

First use

Before using your dishwasher for the first
time:
• Ensure that the electrical and water con-
nections comply with the installation in-
structions
• Remove all packaging from inside the ap-
pliance
• Set the water softener level

Set the water softener

The dishwasher is equipped with a water
softener designed to remove minerals and
salts from the water supply, which would
have a detrimental or adverse effect on the
operation of the appliance.
Indicator lights
Comes on when the rinse aid has run out.
gress indicator light is off. The appliance is in
setting mode.
Always remember that when performing
the following operations:
– selecting a washing programme,
– setting the water softener level,
– activating/deactivating the rinse aid,
the appliance MUST be in setting mode.
Press the On/Off button. Only 1 programme
button light comes on. The programme in
progress indicator light comes on. The last
performed or selected programme is still set.
In this case, to return to setting mode, the
programme has to be cancelled.
To cancel a set programme or a
programme in progress
Simultaneously press and hold the two func-
tion buttons B and C until all the programme
button lights and the programme in progress
indicator light come on. The programme has
been cancelled and the machine is now in
setting mode.
• Pour 1 litre of water into the salt container
and then fill with dishwasher salt
• Fill the rinse aid dispenser
If you want to use combi detergent
tablets such as: ''3 in 1'', ''4 in 1'', ''5
in 1'' etc... set the Multitab function.
(See ''Multitab function'').
The higher the content of these minerals and
salts, the harder your water is. Water hard-
ness is measured in equivalent scales, Ger-
man degrees (dH°), French degrees (°TH)
electrolux 77