Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
SPECIFICATIONS
Cordless disc grinder
Model
Voltage
No-Load speed
outer dia. × hole dia.
Wheel
peripheral speed
Rechargeable battery
Weight
Charger
Model
Charging voltage
Charging time
Weight
Charge time is approximate. Actual charge time may vary.
STANDARD ACCESSORIES
1 Depressed center wheel ........ 1
2 Wrench ..................................... 1
G18DL(S)
3 Side handle ............................. 1
4 Charger ..................................... 1
(2MRK)
5 Battery ...................................... 2
6 Plastic case .............................. 1
1 Depressed center wheel ........ 1
2 Wrench ..................................... 1
3 Side handle ............................. 1
G18DL(S)
4 Charger ..................................... 1
(MRK)
5 Battery ...................................... 1
6 Plastic case .............................. 1
G18DL(S)
Without charger, battery,
(NN)
plastic case
Standard accessories are subject to change without
notice.
APPLICATIONS
Removal of casting fin and finishing of various
types of steel, bronze and aluminum materials and
castings.
Grinding of welded sections or sections cut by
means of a cutting torch.
Grinding of synthetic resins, slate, brick, marble, etc.
Cutting of synthetic concrete, stone, brick, marble,
and similar materials.
8
3.0 Ah
2.0 Ah : Ni-Cd
2.6 Ah : Ni-MH
3.0 Ah : Ni-MH
3.3 Ah : Ni-MH
3.0 Ah : Li-ion
G18DL(S)
18V
9100 min
125 × 22 mm
80 m/s
EBM1830: Li-ion (10 cells)
1.9 Kg
UC18YRL
7.2 – 18 V
30 min.
40 min.
45 min.
50 min.
45 min.
0.6 Kg
BATTERY REMOVAL/INSTALLATION
1. Battery removal
Hold the handle tightly and push the battery latch
to remove the battery (See Fig. 1).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (See
Fig. 1).
CHARGING
Before using the cordless disc grinder, charge the battery
as follows.
1. Connect the charger's power cord to a receptacle
When the power cord is connected, the charger's
pilot lamp will blink in red (At 1-second intervals).
2. Insert the battery into the charger
Insert the battery firmly, until it contacts the bottom
of the charger compartment.
CAUTION
If the battery is inserted in the reverse direction,
not only recharging will become impossible, but it
may also cause problems in the charger such as
deformed recharging terminal.
3. Charging
When inserting a battery in the charger, charging
will commence and the pilot lamp will light up
continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red (At 1-second intervals) (See
Table 1).
-1
Werbung
Inhaltsverzeichnis
