ULTIMATE SPEED ULGD 3.8 A1 Originalbetriebsanleitung Seite 22

■ Do not use the charger for charging non-
rechargeable batteries.
■ Do not use the charger for charging lithium-ion
batteries.
■ Place the removed battery in a well-ventilated
location during charging.
■ The automatic mode of operation and usage
restrictions are explained below in these operat-
ing instructions.
DANGER OF ELECTRIC SHOCK!
■ Do not operate the appliance with a damaged
cable, supply cord or mains plug. A damaged
power cord causes danger to life by electric shock.
■ If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualifi ed persons in order to avoid a hazard.
■ Before connecting to the power, ensure that the
power connection is earthed, is 230 V ∼ 50 Hz,
and is 16 A fused and equipped with an RCCB
switch (residual current circuit breaker) in
accordance with the current regulations!
■ Disconnect the charger from the grid, before you
make or break connections to the battery.
■ First, connect the clamp that is not connected to
the bodywork. Then connect the other clamp to
the bodywork, away from battery and fuel pipe.
Only after this, connect the charger to the grid.
■ After charging, disconnect the charger from the
grid. Only after this remove the clamp from the
bodywork. Following this, remove the clamp from
the battery.
ULGD 3.8 A1
DANGER OF EXPLOSION
AND FIRE HAZARD!
Protect yourself from a highly explosive hydrogen-
oxygen reaction!
■ Ensure that during charge and charge retention
procedures, there are no naked lights (fl ames,
cinders or sparks)!
■ Ensure that the plus cable does not come into
contact with fuel lines (e.g. petrol pipe)!
■ Ensure that there is no possibility of ignition of ex-
plosive or fl ammable substances, such as petrol
or solvents, while using charger!
■ Ensure that there is adequate ventilation during
charging.
DANGER OF CHEMICAL BURNS!
■ Wear protective glasses! Wear protective gloves!
If eyes or skin has come into contact with battery
acid, rinse the aff ected body region off with a
large amount of clean water and consult a doc-
tor straight away!
■ Avoid causing a short circuit when connecting
the charger to the battery. Connect the negative
pole connector cable only to the negative bat-
tery or to the body work. Connect the positive
pole connector cable only to the plus pole of
the battery!
■ Do not place the charger close to fi re, heat or
to places with long-term exposure to tempera-
tures over 50 °C!
■ Ensure that no fuel lines,electric cables, hydrau-
lic or water pipes are damaged by the screws
during assembly of the charger!
■ Do not cover the charger with any objects!
■ Protect the electrical contact surfaces of the bat-
tery from short circuiting!
■ Only use the charger for charging and for
charge retention of 6 V / 12 V lead batteries.
Do not charge frozen batteries.
GB
19