AEG HC452021EB Benutzerhandbuch Seite 14

14 www.aeg.com
Problem
You cannot activate the out-
er ring.
There is a dark area on
the multiple zone.
The sensor fields become
hot.
There is no signal when you
touch the panel sensor
fields.
comes on.
comes on.
and a number come on.
comes on.
E6 comes on.
comes on.
Possible cause
The highest heat setting is
set.
It is normal that there is a
dark area on the multiple
zone.
The cookware is too large or
you put it too near to the
controls.
The signals are deactivated.
Automatic Switch Off oper-
ates.
The Child Safety Device or
the Lock function operates.
There is an error in the hob.
The electrical connection is
incorrect. The supply voltage
is out of range.
The second phase of the
power supply is missing.
The cooling fan is blocked.
Remedy
The highest heat setting has
the same power as the func-
tion.
Activate the inner ring first.
Put large cookware on the
rear zones if possible.
Activate the signals.
Refer to "Daily use" chapter.
Deactivate the hob and acti-
vate it again.
Refer to "Daily use" chapter.
Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If comes on again, speak
to an Authorised Service
Centre.
Speak to a qualified electri-
cian to check the installation.
Check if the hob is correctly
connected to the electrical
supply. Remove the fuse,
wait one minute, and insert
the fuse again.
Check if objects block the
cooling fan. If comes on
again, speak to an Author-
ised Service Centre.