Installing The Unit On A Left-Hand-Drive Car - Pioneer DEH-P90DAB Installationsanleitung

Installing the Unit on a Left-Hand
Drive Car
Note:
• When the unit is installed on a right-hand-drive
car, the horizontal positions are inverted.
1. Secure inner holder to the inner cir-
cumference of the steering wheel
with belt. (Fig. 10)
• Fit the inner holder to the steering wheel so
that the arrow-marked side faces the driver as
shown below.
Belt
2. Cut the extra portion of the belt at
the center of the inner holder.
(Fig. 11)
• Keep the cut-off portion of the belt as a
spare.
Inner holder
Fig. 10
Fig. 11
3. Install outer holder on the inner
holder and secure with screws.
(Fig. 12)
• Tighten the screws with the supplied hexago-
nal wrench.
Screw
Outer holder
4. Install the remote control unit in
the holder. (Fig. 13)
• When removing the remote control unit from
the holder, move the corrugated release sec-
tion toward the steering wheel and slide the
remote control unit toward you.
Release Section
Fig. 12
Fig. 13
10