Installing The Unit On A Left-Hand-Drive Car - Pioneer DEH-P8400MP Installationsanleitung

Installing the Unit on a Left-Hand-
Drive Car
Note:
• When the unit is installed on a right-hand-drive
car, the horizontal positions are inverted.
1. Secure inner holder to the inner cir-
cumference of the steering wheel
with belt. (Fig. 8)
• Fit the inner holder to the steering wheel so
that the arrow-marked side faces the driver as
shown below.
Belt
2. Cut the extra portion of the belt at
the center of the inner holder.
(Fig. 9)
3. Install outer holder on the inner
Inner holder
4. Install the remote control unit in
Fig. 8
Fig. 9
holder and secure with screws.
(Fig. 10)
• Tighten the screws with the supplied hexago-
nal wrench.
Screw
Outer holder
the holder. (Fig. 11)
• When removing the remote control unit from
the holder, move the corrugated release sec-
tion toward the steering wheel and slide the
remote control unit toward you.
Release Section
Fig. 10
Fig. 11
8