Installation - IKEA TYDLIG Anleitung

ENGLISH

Installation

Manufacturer is not responsible for any in-
jury to persons and pets or damage to
property caused by failure to comply fol-
lowing requirements.
Caution! To proceed with the
installation refer to the assembly
instructions.
Warning! Installation process must
follow the laws, ordinances, directives
and standards (electrical safety rules and
regulations, proper recycling in accordance
with the regulations, etc.) in force in the
country of use!
Warning! The appliance must be
earthed!
Warning! Risk of injury from electrical
current.
• The electrical mains terminal is live.
• Make electrical mains terminal free of
voltage.
• Loose and inappropriate plug and socket
connections can make the terminal over-
heat.
• Have the clamping connections correctly
installed.
• Use strain relief clamp on cable.
• Follow the connection diagram (it is loca-
ted on the underneath surface of the
casting of the hob).
Important! You must observe the minimum
distances to other appliances and furniture
cabinets or other units according to
Assembly Instruction.
If there is no oven beneath the hob insert a
dividing panel at a minimum distance of 20
mm from the bottom of the hob.
Do not use silicon sealant between the ap-
pliance and the worktop. Avoid installing
the appliance next to doors and under win-
dows as hot cookware may be knocked off
the rings when doors and windows are
opened.
Only an authorized service engineer can in-
stall, connect or repair this appliance. Use
only original spare parts.
Electrical connection
Before connecting, check that the nominal
voltage of the appliance stated on the rat-
ing plate, corresponds to the available sup-
ply voltage. Also, check the power rating of
the appliance and ensure that the wire is
suitably sized to suit the appliance power
rating (refer to the Technical data chapter).
The rating plate is located on the lower cas-
ing of the hob.
The appliance is not provided with mains
cable. Buy the right one from specialized
dealer. Single-phase or two-phase connec-
tion requires the mains cable of type H05
BB-F/H05V2V2-F Tmax 90°C (equal or
higher).
The appliance works perfectly on AC 230 V,
AC220V~ or AC240V~ 50Hz electrical net-
work.
You must have the means for disconnection
incorporated in the fixed wiring. Have the
appliance connected to the mains using a
device that allows the appliance to be dis-
connected from the mains at all poles with a
contact opening width of at least 3 mm, eg.
automatic line protecting cut-out, earth
leakage trips or fuse.
You must have the connection and the con-
necting links carried out as shown in the
connection diagram (it is located on the un-
derneath surface of the casting of the hob).
The earth lead is connected to terminal
marked with the symbol
longer than leads carrying electric current.
Tighten the terminal screws securely! Finally,
secure the connecting cable with the mains
cable cleat and the covering closed by
pressing firmly (lock into place).
Warning! Once connected to the
mains supply check that all cooking
zones are ready for use by briefly setting
each to maximum power.
12
and must be