When Installing The Aerial Outside The Vehicle (On The Body); When Routing The Lead In From Inside The Boot; When Routing The Lead In From The Top Of The Door - Pioneer AVIC-X3-II Installationshandbuch

Section
04 Installation

When installing the aerial outside the vehicle (on the body)

Put the GPS aerial in a position as level as possible, such as on the roof or boot lid. (The GPS aerial is fastened with a
magnet.)
When routing the lead in from inside
the boot
Fig. 1
Clamps
Use clamps to secure the
lead where necessary in-
side the vehicle.
Rubber packing
28
Engb
GPS aerial
Fig. 1
Waterproof pad
Make sure the waterproof
pad contacts the top of
the rubber packing.
Make a U-shaped loop in
the lead outside the rub-
ber packing to prevent
rainwater from flowing
along the lead into the in-
terior of the vehicle.
Fig. 2
When routing the lead in from the
top of the door
Fig. 2
Make a U-shaped loop in the lead on the outside to
prevent rainwater from flowing along the lead into the
interior of the vehicle.
Clamps
Use clamps to secure the lead where
necessary inside the vehicle.