When Installing The Aerial Inside The Vehicle (On The Rear Shelf) - Pioneer AVIC-X3-II Installationshandbuch

Installation

When installing the aerial inside the vehicle (on the rear shelf)

Affix the metal sheet on as level a surface as possible where the GPS aerial faces the window. Place the GPS aerial on
the metal sheet. (The GPS aerial is fastened with its magnet.)
Metal sheet
Peel off the protective sheet on the rear.
Make sure the surface is free of moisture, dust, grime,
oil, etc., before affixing the metal sheet.
Notes
! The metal sheet contains a strong adhesive
which may leave a mark on the surface if it is
removed.
! When attaching the metal sheet, do not cut it
into small pieces.
! Some models use window glass that does not
allow signals from GPS satellites to pass
through. On such models, install the GPS aer-
ial on the outside of the vehicle.
GPS aerial
Clamps
Use clamps to secure the lead where necessary inside
the vehicle.
Section
04
27
Engb