Installing The Hide-Away Unit - Pioneer AVIC-X3-II Installationshandbuch

Installation
Rubber bush
Flush surface screw
(5 mm × 6 mm)
(4 pcs.)
Fixing screw
(2 pcs.)
CAUTION
! Install with the left and right sides of the
hide-away unit parallel to your vehicle's
direction of travel. Do not install diagon-
ally to your vehicle's direction of travel or
the current location will be displayed in-
correctly.
Forward/Backward direction of vehicle
! Be sure to install the hide-away unit on
the floor with the silk printing side is fa-
cing up. The navigation system will oper-
ate properly only in this position.
Binding screw
(5 mm × 6 mm)
(4 pcs.)
Screw
(4 mm × 3 mm)
(4 pcs.)

Installing the hide-away unit

1 Attach the side brackets to the hide-
away unit.
When the hide-away unit is installed on the
floor or the installation board under the pas-
senger seat, etc., the side brackets should be
attached to the unit.
Use the following holes in the side brackets.
If the positions of the side brackets are shifted in par-
allel you can also use other holes that match up with
the holes in the hide-away unit.
Side bracket
When the hide-away unit is installed under the
passenger seat, etc., use the installation
board.
2 Decide on the installation position, and
drill the holes.
Installation board
Section
04
Washer faced
screw
(4 mm 8 mm)
Mark up the
positions for
drilling the holes.
23
Engb