Cleaning The Appliance - Bosch KUL Serie Gebrauchsanleitung

en

Cleaning the appliance

1. Attention: Pull out the mains plug
or switch off the fuse!
2. Wipe the door seal with clear water only
and then wipe dry thoroughly.
3. Clean the appliance with lukewarm
water and a little washing up liquid.
The rinsing water must not get into the
temperature selector or light, Fig. 2.
4. After cleaning: reconnect and switch
on the appliance.
Do not use abrasive or acidic cleaning
agents and solvents.
Regularly clean the condensation channel
and drainage hole, Fig. 3, with a cotton
bud or similar implement to ensure that
the condensation can drain.
The rinsing water must not run through
the drain hole into the evaporation pan.
Attention!
Never clean the shelves or containers in
the dishwasher. The parts may warp!
If appliances feature a ventilation grille in
the base, the panel can be removed for
cleaning. To do this, depress the clips in
the ventilation slots and simultaneously
remove the base panel forwards. Fig. e
28
Important care information
for stainless steel
appliances
Use Chromol" cleaning agent for
cleaning stainless steel surfaces.
This cleaning agent is available on the
market under the name Chromol" or from
your customer service under
ident no. 310359 as a 500 ml spray can
or under
ident no. 166787 as a 50 ml trial can.
To prevent damage to the surfaces, under
no circumstances use abrasive sponges,
metal brushes, sharp edged implements
or scouring agents. Chemically aggressive
cleaning agents, such as defrosting
sprays, oven sprays, solvents or stain
removers must not be used either.
The stainless steel surface should be
cleaned in the direction of the grain.