Eliminating Minor Faults Yourself - Bosch GSN Serie Gebrauchsanleitung

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs
greatly from the set
value.
The light does not
work.
Displays
do not illuminate.
Display indicates "E..". Electronics module
Possible cause
The bulb is defective.
Light switch is
jammed.
Power failure; the fuse
has been switched off;
the mains plug
has not been inserted
properly.
defective.
Remedial action
In some cases it is adequate
to switch off the appliance
for 5 minutes.
If the temperature is too high wait
a few hours and check whether
the temperature has approached
the set value.
If the temperature is too low check
the temperature again the next day.
Replace bulb. Fig. */B
1. Switch the appliance off.
2. Pull out mains plug or switch off
fuse.
3. Slide cover forwards and remove.
4. Change the bulb.
(Replacement bulb:
220–240 V a.c., E14 bulb holder,
see defective bulb for wattage.)
Check whether it can be moved.
Fig. */A
Connect mains plug. Check whether
the power is on, check the fuses.
Call customer service.
en
35