Eliminating Minor Faults Yourself - Bosch GSN Serie Gebrauchsanleitung

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice, even if the appliance is still under
guarantee!
Fault
Temperature differs greatly
from the set value.
Light does not function
Displays do not illuminate.
E2" is displayed, Fig. 2/1.
Possible cause
The bulb is defective. Fig. 8/A
Light switch is sticking.
Fig. 8/B
Power failure!
S The fuse has tripped.
S The mains plug has not been
inserted properly.
Electronics module defective
Remedial action
In some cases it is adequate to switch
off the appliance for 2 minutes.
If the temperature still differs try
again after an hour.
If the temperature is too high wait
a few hours and check whether the
temperature has approached the set
value.
If the temperature is too low check
the temperature again the next day.
Replace defective bulb.
1. Pull out the mains plug or
disconnect the fuse.
2. Remove cover forwards.
3. Change the bulb
(replacement bulb max. 15 W,
220 240 V a.c., E14 lampholder)
Check whether it can be moved.
If not, please call customer service.
Check whether the power is on,
the fuse must be switched on.
Call customer service
en
27