Crossfader - Rodec MX180 MK3 Bedienungsanleitung

RODEC
This switch has no influence on the master outputs.
25)

Crossfader

With this fader you can easily fade over between the channels 1-2 and 3-4. When the knob
stands completely to the left the signal of the channels 1 and 2 will appear on the output.
When the knob stands completely to the right will the signal of the channels 3 and 4 will
appear on the output.
CONNECTIONS
A) PHONO input
Phono input with a sensitivity of 2.3mV and build in RIAA correction.
B) Ground
If the recordplayer has a ground wire, connect it to the ground terminal.
C) MD/AUX input
Input with a sensitivity of 220mV. To connect different apparatuses such as a tuner, tape
recorder, mini disc, cassette recorder or (HIFI) video recorder.
D) CD/DAT input
Input for compact disc players and digital tape recording.
E) Micro input
Balanced microphone input. To reduce the interference on the microphone cord, you have to
use a microphone with balanced output. The use of a microphone without balanced output is
also possible, in this case please get in contact with your RODEC dealer.
F) Recording outputs
Outputs to connect cassette recorder or (HIFI) video recorders to make recordings. These
outputs can be switched with or without recording the DJ microphone signal. (24)
G) DJ mike input
Balanced microphone input with a sensitivity of 0.7mV.
This input is in combination with the input JACK (16) on the front of the set. The JACK (16)
has priority on the XLR input (G) on the back of the set.
H) Effects IN/OUT
Input and output to connect effect apparatus to the microphone channel. If there is no plug in
the JACK, the microphone channel works normally, if there is a plug inserted in the JACK, the
internal link is interrupted. The sensitivity of this IN/OUT connection is 160mV.
I) Master output 1
Symmetrical output to connect a power-amplifier. The output level can be manipulated with
the master fader 1 (22) from 0 to maximum (3.3V).
J) Master output 2
Assymetrical output to connect a power-amplifier. The output level can be manipulated with
the master fader 1 (22) from 0 to maximum (1.55V).
K) Monitor output
Extra output from where the output voltage can be controlled from 0 to maximum (775mV)
with the monitorfader (23). The musiccompressor, the DJ-micro and the mono/stereo switch
have no influence on this output.
L) Remote control terminal option
The terminal is completely independent of the electronics of this set.
Only for switching low current/low voltage.
MX180
MKIII
5