Lathe Chuck / Faceplate Assembly; Top Slide - Holzmann Ed750Fd Betriebsanleitung

OPERATION

14.2.13 Lathe chuck / faceplate assembly

If you mount the rotary chuck or chucks want to dismantle or, first make sure that the holding
cams are fixed.
 Loosen the three screws (A) and lift off the lathe chuck.
 Now mount chuck or faceplate on the spindle head and tighten the bolts in sequence to.
 Do not replace food or face plates between different lathes, without checking the correct ad-
justment cams.
A (3x)

14.2.14 Top slide

For angular adjustment of the upper slide, loosen the screws, turn the
carriage to the desired position and fix the carriage again with the
screws.
Adjusting screws (1)
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at Seite 39
METALLDREHMASCHINE / METAL TURNING LATHE ED 750FD