Cleaning And Maintenance; Service - Parkside PABS 18-Li B2 Originalbetriebsanleitung

Preparing the tool for use / Cleaning and Maintenance / Service / Warranty
Soft screwdriving conditions (e.g. into
soft wood):
Y ou should also select a low speed in order not to
damage the wood workpiece surface through con-
tact with the metal screw head. Use a countersinker.
When drilling into wood, metal and other
materials, take note of the following advice:
W ith small diameter drill bits use a high drill
speed. For large diameter drill bits, use a low
drill speed.
F or hard materials, select a low drill speed.
For soft materials, select a high drill speed.
S ecure or fix down the workpiece (if possible)
in a clamp or vice.
M ark the intended position of the hole with a
centre punch or a nail and select a low drill speed
for drilling.
T ake the rotating drill bit out of the hole frequently
so that swarf or drill dust can be re-moved and
the hole and tool is ventilated.
Drilling in metal:
U se a metal drill bit (HSS). For the best results,
you should cool the bit with oil. Metal drill bits
can also be used to drill into plastic.
Drilling in stone:
U se a circular shafted masonry drill bit with a
hardened metal tip.
Drilling in wood:
N ormally you should use a wood drill with a
centring point. For deep holes, use an auger type
bit. For large diameter holes, use a forstner bit.
You can screw small screws into soft wood
without the need for pre-drilling.

Cleaning and Maintenance

Q
CAUTION! Place the direction of rotation
switch into the middle position before carry-
2
ing out any tasks on the device, e.g. changing
tools or maintenance, or before transporting or
storing the device. Inadvertent operation of the
ON / OFF switch
3
may result in injury.
P ull the mains lead out of the mains socket eve-
ry time and remove the battery before you clean
or maintain the device.
The Cordless drill is maintenance-free.
A lways keep the device clean, dry and free of
oil or grease.
C lean the device immediately after you have
finished using it.
D o not allow any liquids to enter the device.
Use a cloth to clean the housing. Never use
petrol, solvents or cleaning agents that might
attack plastic.

Service

Q
Have your device repaired
at the service centre or by qualified
specialist personnel using original
manufacturer parts only. This will ensure
that your device remains safe to use.
If the plug or lead needs
to be replaced, always have the
replacement carried out by the manu-
facturer or its service centre. This will
ensure that your device remains safe to use.
Warranty
Q
The warranty for this appliance is for 3
years from the date of purchase. The ap-
pliance has been manufactured with care
and meticulously examined before deliv-
ery. Please retain your receipt as proof
of purchase. In the event of a warranty
claim, please make contact by telephone
with our Service Department. Only in this
way can a post-free despatch for your
goods be assured.
The warranty covers only claims for material and
maufacturing defects, but not for transport damage,
for wearing parts or for damage to fragile compo-
nents, e.g. buttons or batteries. This product is for pri-
vate use only and is not intended for commercial use.
GB 25