Danger Of Fire - EuroLite LED IP T1000 QCL Bedienungsanleitung

Procedure:
The device should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the device. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and.or
damage to property.
The device has to be installed out of the reach of people.
If the device shall be lowered from the ceiling or high joists, professional trussing systems have to be used.
The device must never be fixed swinging freely in the room.
Caution: Devices may cause severe injuries when crashing down! If you have doubts concerning the safety
of a possible installation, do NOT install the device!
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
The mounting brackets on the rear panel can be moved to
the desired position. Loosen the two plastic fixing screws with
an appropriate screw driver. Shift the mounting bracket to the
desired position and screw the fixing screws tight again.
Mount the device with mounting-brackets to your trussing
system using appropriate clamps.
For overhead use, always install an appropriate safety bond.
You must only use safety bonds and quick links complying
with DIN 56927, shackles complying with DIN EN 1677-1 and
BGV C1 carbines. The safety bonds, quick links, shackles
and the carbines must be sufficiently dimensioned and used
correctly in accordance with the latest industrial safety
regulations (e. g. BGV C1, BGI 810-3).
Please note: for overhead rigging in public or industrial
areas, a series of safety instructions have to be followed that
this manual can only give in part. The operator must therefore inform himself on the current safety
instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Pull the safety bond through the hole in the mounting-bracket and over the trussing system or a safe fixation
spot. Insert the end in the quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already held the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!

DANGER OF FIRE!

DANGER TO LIFE!
27/40 00102016, Version 1.0