Trimming Without Add-Ons; Thinning Your Hair; Cutting The Edges Of The Hairline, Neck And Sideburns; Trimming And Cutting Your Beard - Silvercrest SHBS 1000 B1 Bedienungsanleitung

Trimming without add-ons

GB

Thinning your hair

♦

Cutting the edges of the hairline, neck and sideburns

♦
♦
♦

Trimming and cutting your beard

♦
♦
38
WARNING
► The trimmer block
You can cut your hair to lengths between 0.5 mm and 2.5 mm without using a
cut length add-on . Move the slide switch
7
adjust the cutting length.
NOTE
► Depending on how you hold your hair and beard trimmer and the resulting
angle, the cut length can vary from the lengths stated in this operating
manual and marked on the add-on/appliance.
You can use this function to reduce the volume of your hair because only part
of the hair is gripped and trimmed.
To thin your hair, clip the thinner add-on
front until it engages. When doing so, the thinner add-on
the trimmer head teeth.
Turn the appliance round so that the rear side is facing upwards.
Place the edge of the trimmer block
required height along the hairline.
Switch the hair and beard trimmer on and move it downwards.
Select a cut length add-on depending on the required beard length.
Now trim your beard in stages.
is very sharp. There is a risk of personal injury!
to the required length to fi ne-
2
onto the trimmer block
8
without a cut length add-on
from the
must protrude past
8
at the
7
SHBS 1000 B1