Silvercrest SHBS 1000 B1 Bedienungsanleitung Seite 40

Cut length add-ons
♦ Select a suitable cut length add-on
mm / 7 - 9 mm / 10 - 12 mm / 16 - 18 mm / 22 - 24 mm / 28 - 30 mm).
♦ Click the selected cut length add-on
Ensure that both pins in the cut length add-on
cutouts in the trimmer head holder.
♦ You can use the slide switch
length
length add-on
fi ne length adjustment upwards as far as possible (0.5 mm).
NOTE
► Variable adjustment of the fi ne adjustment downwards increases the cut
length to 22.5 mm (with fi ne adjustment 1.0 mm); to 23 mm (with fi ne
adjustment 1.5 mm) or to 24 mm (with fi ne adjustment 2.5 mm).
Cut length
add-on
10 - 12
16 - 18
22 - 24
28 - 30
* Please note that the cut length can deviate from the stated length depending
on the angle of cut.
♦ Switch the hair and beard trimmer on by pressing the ON - OFF switch
♦ Run the hair and beard trimmer slowly through your hair.
♦ When doing so, hold the appliance so that the selected cut length add-on
as fl at as possible against your scalp.
♦ Always cut from your neck towards the top of your head, or from your forehead
and temples upwards towards the middle of the head.
SHBS 1000 B1
:
7
2
. For example, if you want to cut your hair to 22 mm length, take a cut
7
for hair lengths of 22-24 mm and push the slide switch
7
Cut length* with fi ne length adjustment (mm)
(mm)
7
0.5
4 - 6 4
7 - 9 7
10
16
22
28
to match your required hair length (4 - 6
7
onto the trimmer block
7
correctly locate into the side
7
to make fi ne adjustments to the required cut
1.0 1.5
4.5 5
7.5 8
10.5 11
16.5 17
22.5 23
28.5 29
from behind.
for
2
2.0 2.5
5.5 6
8.5 9
11.5 12
17.5 18
23.5 24
29.5 30
3 .
is
7
37
GB