Getting Started; Replacing The Battery; Unit Conversion Button - Silvercrest Z29852A Bedienungs- Und Sicherheitshinweise

Safety Instructions / Getting started
the event of contact with battery
acid, rinse the affected area
with plenty of clean water and
consult a doctor immediately.
Remove light dirt from the bat-
tery and product contacts with a
dry, non-fluffing cloth before
inserting the batteries.
Remove the battery from the
product if it is not in use for any
length of time.
Make sure that the polarity is correct
when you insert the battery. This
is indicated in the battery com-
partment. The battery can other-
wise explode.
Insert the battery with care.
The product can otherwise be
damaged.
Please do not dispose of used
batteries in your household
waste but take them to a desig-
nated collection depot for
special waste.

Getting started

Q
1. Open the battery compartment
scale by pushing the clip
compartment cover
compartment and lift up the cover.
2. Remove the battery isolating strip
the battery metal contact to which it is attached.
3. Place the battery compartment cover
on the battery compartment
two extensions
13
8 GB/IE
96498_silv_Digitale_Kuechenwaage_Content_GB_IE_FI_SE_DK.indd 8
under the
15
on the battery
7
towards the battery
8
from under
16
back
8
. Ensure that the
15
on the battery compartment
cover fit into the two notches
8
edge of the battery compartment opening
when the cover is closed. Press the battery
compartment cover
8
compartment until you hear it engage.
15
16

Replacing the battery

Q
1. Switch off the scale. Press and hold down the
On / Off / Zero button
2. Open the battery compartment
above.
3. Remove the exhausted batteries from the battery
embedding case by pressing the black bat-
11
tery locking tab . The battery is automatically
12
released from the battery embedding case
Ensure that you do not exert too much force on
the contact , otherwise it could be damaged
10
by over-bending as the battery is lifted. Remove
the battery from the battery embedding case
4. Insert a new battery into the battery embedding
case . Make sure you fit the battery the right
11
way round (polarity). The "+"- side must face
upwards. The metal contact
into position.
5. Close the battery compartment
above.

Unit conversion button

Q
j
T he unit conversion button
weight can be found on the bottom of the kitchen
scale. By simply pressing the button the units of
measure change between metric (g, ml) and
imperial (lb:oz, fl'oz).
Note:
– If the units of weight are set to metric (g) then
the units of volume will be automatically shown
as ml.
on the
14
firmly on to the battery
12
11
for 3 seconds.
5
as described
15
.
11
.
11
presses battery
10
as described
15
for the units of
9
19.11.13 08:21