Set-Up - Clearaudio CONCEPT Bedienungsanleitung

Concept
User manual / Bedienungsanleitung

3. Set-up

concept
Setting up the turntable is easy. The turntable chassis, tonearm and cartridge are
already assembled and all key parameters have been pre-adjusted and tested at the
Clearaudio factory.
oncept
The c turntable requires a place for set-up
Location of at least 17 inch x 14 inch.
to 1.)
1.)
concept
First take the turntable chassis out of the
package and place it on a suitable surface. Then
remove the drive belt from the plastic bag.
to 2.)
2.)
Place the drive belt around the sub-platter and around
the motor pulley.
to 3.)
3.)
Take the platter out of the package and carefully
Place it with both hands onto the shaft.
4.)
to 4.)
Carefully remove the adhesive security
tape and further security materials from the
tonearm and the cartridge.
to 5.)
5.)
As all key parameters have been adjusted at the
Clearaudio factory, all you need to do is to level
The turntable using the level gauge provided.
Page/ Seite 4  clearaudio electronic GmbH 2015