Set Up - Clearaudio CONCEPT MC Bedienungsanleitung

Concept
MC
User manual / Bedienungsanleitung

3. Set up

Concept -
The set up of the turntable is easy as the turntable chassis, tonearm and the
cartridge are pre-assembled and all parameters have been already adjusted and tested at
the Clearaudio factory.
Concept
The - turntable requires a place for set-up of at least 17 inch x 14 inch.
1.)
Concept
Please take first the - turntable chassis out of the package and place it on a
suitable surface. After that please take the accessory box out of the package.
2.)
Please remove the adhesive security tape from the sub-platter. PLEASE RETAIN ALL
ORIGINAL PACKAGING. You will need it, if your turntable needs to be transported and/or
shipped.
Pic. 2: Removing the security tape
3.)
Take the drive belt out of the accessory box and place it around the sub-platter and around
the motor pulley.
4.)
Take the platter out of the package and place it carefully with both hands onto the shaft.
Pic. 3: Set up of the platter
5.)
Now remove carefully the adhesive security tape
from the tonearm and the MC cartridge.
PLEASE RETAIN ALL ORIGINAL PACKAGING. You
will need it, if your turntable needs to be
transported and/or shipped.
Pic. 4: Removing the tapes
Page/ Seite 4  clearaudio electronic GmbH 2014