Cleaning And Care; Storage - Silvercrest SSM 180 A1 - IAN 96281 Bedienungsanleitung

NOTE
► If the ingredients do not mix properly, it may
be necessary to lift up the appliance and
shake it a little. When doing so, hold the
blade holder 4 together with the blender
jug 1 and the base 5 so that they do not
come apart.
GB
ATTENTION! DAMAGE TO PROPERTY!
► Do not operate the appliance for longer than
1 minute in one session. The appliance will
overheat! After using for 1 minute, allow the
appliance to cool down completely.
8) When the smoothie is ready, turn the blade
holder 4 until the arrow on the base 5 points
symbol on the blade holder 4 and
to the
remove the blade holder 4 with the attached
blender jug 1.
9) Turn the blender jug 1 over and unscrew the
blade holder 4.
10) Screw the lid 2 off the blender jug 1. You
can drink the smoothie through the drinking
opening on the lid 2.
You can now prepare a second smoothie using
the second blender jug 1.

Cleaning and care

DANGER – ELECTRIC SHOCK!
► Before cleaning the appliance, disconnect
the plug from the mains power socket!
Risk of electric shock!
NEVER submerse the base 5 in water or
other fl uids!
■ It is best to clean the appliance directly after use.
This makes food residues easier to remove.
ATTENTION! DAMAGE TO PROPERTY!
► Do not use abrasive or aggressive cleaning
materials. These could damage the surface
of the appliance!
26
Wipe the base 5 with a moist cloth. For stubborn
■
soiling use a mild detergent on the cloth.
Wipe off any detergent residue with a cloth
moistened with clean water.
Clean the blender jug 1, the blade holder 4
■
with blade 3 and the lid 2 in warm water with
a little mild detergent. Afterwards, rinse all parts
with clean water so that no detergent residues
remain.
NOTE
If you clean the appliance directly after use, you
will usually achieve suffi ciently hygienic cleaning
results for the blender jug 1 and the blade
holder 4 by using the following alternatives:
Fill the blender jug 1 with 400 ml of water
►
and add a few drops of mild detergent.
Attach the blade holder 4 and screw both
►
onto the base 5.
Press the start button 6 a few times so that
►
the blade 3 ploughs through the water.
Afterwards, rinse the blender jug 1 and the
►
blade holder 4 with plenty of clear water
so that all detergent residues are removed.
■ After cleaning, dry all parts thoroughly.
NOTE
You can also clean the lid 2, the blender
►
jug 1 and the blade holder 4 in your
dishwasher. Place the parts, where possible,
in the upper basket and ensure that none of
the parts can get stuck. Otherwise they could
become deformed.

Storage

■ Store the cleaned appliance in a clean, dust-free
and dry location.
SSM 180 A1