Removing And Refitting The Door Panels; Troubleshooting; Malfunction Table; Replacing The Bulb In The Oven Ceiling Light - Siemens HC724220 Gebrauchsanleitung

Attaching the door
Reattach the oven door in the reverse sequence to removal.
When attaching the oven door, ensure that both hinges are
1.
inserted straight into the opening (figure A).
The notch on the hinge must engage on both sides (figure B).
2.
Fold back both locking levers (figure C). Close the oven
3.
door.
:
Risk of injury!
If the oven door falls out accidentally or a hinge snaps shut, do
not reach into the hinge. Call the after­sales service.

Removing and refitting the door panels

The glass panels can be removed from the oven door to allow
more thorough cleaning.
Removal
Removing the oven door See the section Removing the oven
1.
door. Lay the oven door on a cloth with the handle facing
downwards.
Remove the cover from the top of the oven door. To do this,
2.
press with your fingers on the left and right-hand side. Pull
out the cover (Fig. A).

Troubleshooting

Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.

Malfunction table

If a dish doesn't turn out as well as you had hoped, refer to the
section Tested for you in our cooking studio, where you will
find plenty of cooking tips and tricks.
Problem Possible cause Remedy/information
The oven does The circuit
not work. breaker is
defective.
Power cut
Look in the fuse box and
check that the circuit
breaker is in working order.
Check whether the kitchen
light or other kitchen appli-
ances are working.
Raise the top panel and pull it out (Fig. B).
3.
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Fitting
Hold the top glass panel firmly by the sides and slide it in
1.
towards the back at an angle. The panel must be inserted
into the openings on the lower side. The smooth surface must
face outwards, while the roughened side must be on the
inside. (Fig. A).
Place the cover on the top of the oven door and press in
2.
place. Make sure that the grooves along the sides lock into
position.
Refitting the oven door See the section Refitting the oven
3.
door.
Do not use the oven again until the panels have been
correctly fitted.
Problem Possible cause Remedy/information
The oven does There is dust on
not heat up. the contacts.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.

Replacing the bulb in the oven ceiling light

If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 40 watt spare bulbs can be obtained from our after-
sales service or a specialist retailer. Only use these bulbs.
:
Risk of electric shock!
Switch off the circuit breaker in the fuse box.
Turn the control knobs back
and forth several times.
83