Using For The First Time; Operation - Zgonc New Generation YGL N.G. 159 Betriebsanleitung

– Mount the upper part of handle (3) as
shown and install the control cable without
tension (fig. 7).
Adjust the sliding block (fig. 4)
WARNING!
Risk of injury!
Make sure that the cutting tool guard
is installed on the cutter (11).
NOTICE!
Product damage!
The sliding block (26) must always be correctly
adjusted. An incorrect adjustment can result
in the cutter jumping out of the guide (25) or
damage being caused to the cutting tool (11).
– Pull off the ignition cable connector (18).
– Secure the adjustment screw (24) against
turning with a suitable tool.
– Loosen the nut (23) with a suitable tool.
– Change the height of the adjustment screw (24)
by turning.
– Protect the adjustment screw (24) against
turning with a suitable tool and tighten the nut
(23) again using an appropriate tool.

Using for the first time

Filling with fuel
DANGER!
Risk of injury!
Petrol is highly inflammable!
Before refuelling, switch off the motor and let it
cool down.
Closely observe all safety information for
handling fuel.
NOTICE!
Risk of product damage!
The product is supplied without motor oil.
Make sure it is filled with motor oil before using
for the first time.
28
Note:
Use only appropriate fuel ( Usable
fuels and lubricants).
– Open and remove the tank cover (14).
– Carefully top up the fuel (tank capacity:
Technical data ). Do not spill!
– Check the seal in the tank cover for damage
and clean if necessary. Replace a damaged seal
immediately!
– Re-tighten the tank cover (14) by hand.
Filling with motor oil
Note:
Only use engine oil approved by the
manufacturer (Usable fuels and
lubricants ).
– Unscrew and remove the motor oil filling
plug (12).
– Carefully top up the motor oil (amount of
engine oil: Technical data). Do not spill!
– Re-tighten the motor oil filling plug (12) by
hand.
Set the steering height (Fig. 7):
– Loosen the screws (37).
– Set the required steering height.
– Tighten the screws.

Operation

Check before starting!
NOTICE!
Risk of product damage!
The product is supplied without motor oil.
Make sure it is filled with motor oil before using
for the first time. Operating the motor with
insufficient oil will damage the motor.
Dirty oil or two-stroke motor oil reduces the
service life of the motor. The motor oil must be
changed after the first five to eight operating
hours.