Before Initial Operation; Operation Parameters - Pkm KG 160-3 Bedienungsanleitung

1. When the appliance has been disconnected from the mains or switched off or in
case of a power failure, you must wait 3 to 5 minutes before restarting the
appliance.
2. The description of the setting levels represents standard values only.
3. You can check the cooling/freezing temperature using a fridge/freezer
thermometer (not included in delivery).
WARNING THE THERMOSTAT CONTROLS THE COMPRESSOR
ONLY. You must unplug the appliance to disconnect it from the mains.

4.2 Before initial operation

1. Clean the appliance. Read the information given in chapter
MAINTENANCE
2. Check that the appliance is levelled and ventilated properly.
 You can additionally use a fridge-thermometer
temperature.

4.3 Operation parameters

1. The appliance can only reach the relevant temperatures when:
a. the a ambient temperature meets the climatic class.
b. the doors close properly.
c. you do not open the doors too often or too long.
d. the door seals are in proper condition.
e. the appliance is properly positioned.
f. you have not overfilled the appliance.
g. you do not store warm or hot food in the appliance.
2. The 4**** freezing compartment freezes food at a temperature of -18
lower. The freezing temperature is affected by the room temperature, site and
frequency of door operation.
3. The freezing temperature should not be warmer than -18
4. When the ambient temperature is very high, it is recommended to set the
thermostat to a colder setting if needed. If the colder setting should cause strong
formation of encrusted ice, please select a lower setting.
5. High ambient temperatures and simultaneously operating at the coldest setting
may make the compressor operate permanently to keep the temperature
constant inside the appliance.
4
Not included in delivery
.
4
31
CLEANING AND
to check the cooling
0
C.
0
C or