EuroLite LED TMH-12 Bedienungsanleitung Seite 26

Test mode
Test function of each channel
With this function you can test each channel on its (correct) function.
Language
The display language is English.
Set up
PAN reverse
With this function you can reverse the Pan-movement.
TILT reverse
With this function you can reverse the Tilt-movement.
Fade delay
The dimmer is available in two different versions – with the response characteristics of halogen lamps (ON)
and response characteristics of LEDs (OFF).
Code wheel
With this function you can correct the PAN/TILT movement to the programmed position.
Screen saver
With this function, you can adjust the display characteristics when the buttons are inactive:
Mode 1 - displays the current DMX starting address,
Mode 2 - shuts off the display,
OFF - shows the last used menu point.
Display reverse
With this function you can flip the display by 180° for a better view when the fixture is hung from the truss or
a ceiling.
Reset
With this function you can reset the device via the Control Board.
Factory set
With this function you can restore the factory settings of the device. All settings will be set back to the default
values (shaded).
Motor X off set
With this function, you can calibrate and adjust PAN to the desired position.
Motor Y off set
With this function, you can calibrate and adjust TILT to the desired position.
System Info
On time
With this function, you can display the temporary running time of the device from the last power on.
Run time
With this function, you can display the running time of the device.
Version
With this function you can display the software version of the device.
Running mode
With this function you can display the operating mode of the device.
DMX address
With this function you can display the adjusted DMX address of the device.
Temperature
With this function you can display the temperature in the projector-head.
26/28 00074204.DOC, Version 1.1