Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DESCRIPTION OF THE DEVICE
Features
QCL Moving Head with narrow beam angle
• Equipped with twelve 10 W CREE quadcolor LEDs with RGBW colors
• Compact lightweight
• Narrow beam angle
• Positioning within 630° PAN and 200° TILT
• Stepless RGBW color changing
• Different dimmer speeds (step response) adjustable
• Masterdimmer
• 8 internal programs can be called up via Control board
• Color-macro-function for an easy selection of possible color-combinations
• Strobe effect with 1-18 flashes per second
• Random strobe effect
• Exact positioning via 16 bit PAN/TILT movement resolution
• Automatic position correction
• DMX-controlled operation or stand-alone operation with Master/Slave function
• Sound-control via built-in microphone
• Control board with graphic LCD display for adjusting the DMX-starting address, PAN/TILT reverse,
program, reset, operating hours
• Switch-mode power supply
• Automatic power supply adaption between 100 and 240 Volts without power selector
• DMX control via every standard DMX controller
INSTALLATION
Rigging
The installation of the projector has to be built and constructed in a way that it can hold 10 times the weight
for 1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The projector should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
19/28
00074204.DOC, Version 1.1
Werbung
Inhaltsverzeichnis
