Flight Operation; Description Of Control & Functions - Carson X4 Cage Copter Betriebsanleitung

flIght operatIon

Trimming the quadcopter
Already shortly before the quadcopter takes off, you can recognize
whether it wants to turn or glide in a particular direction. Correct
the deviations from the vertical ascent with the trim knob of the
turn function.
Tip of the fuselage turns to the right:
• Reduce speed and push the trim slider of the turn function on
the left remote control lever stepwise to the left.
• Push the pitch-lever forward again and check whether the
correction was sufficient, if necessary shift the trim further to
the left.
• Repeat the process until the quadcopter no longer shows a
tendency to turn to the right.
Model slips (drifts) or tilts to the right:
• Reduce the speed and push the trim slider of the roll-function of
the right remote control lever stepwise to the left.
• Push the gas-lever forward again and check whether the correc-
tion was sufficient, if necessary shift the trim further to the left.
• Repeat the process until the quadcopter no longer shows a
tendency to drift to the right.
Model slips (drifts) forward:
• Reduce the speed and push the trim slider of the nick function
on the right remote control lever stepwise backwards.
• Push the pitch lever forward again and check whether this was
sufficient for correction, if necessary shift the trim further to the
left.
• Repeat the process until the quadcopter no longer shows a
tendency to drift forwards.
DeScrIptIon of control & functIonS
Tip of the fuselage turns to the left:
• Proceed as described above, but push the trim slider of the turn
function stepwise to the right.
Model slips (drifts) or
tilts to the left:
• Proceed as described above,
but push the trim slider of the
tail function stepwise to the right.
Model slips (drifts)
backwards:
• Proceed as described above,
but push the trim slider of the
nick function stepwise forward.
Calibration function: If the quadcopter drifting always to one side after
start, you should bind the 2.4 GHz signal again and you must put the
model on a horizontal Surface (table, floor).
After you must bring the two control levers in right lower position below
(Fig.) until the LED flash. Then the calibration is complete.
25 // GB