Using The Accessories - IKEA KURVOR Anleitung

ENGLISH
6. When the set time ends, the symbol
or and the set time flash. The acous-
tic signal sounds for two minutes. The
appliance deactivates. Press a button
or open the appliance door to stop the
signal.
If you press
for Duration
switches to setting the End
Setting the Minute Minder
Used to set a countdown time. The maxi-
mum time you can set is 2 hours 30 minutes.
This function has no effect on the operation
of the oven. You can set the Minute Minder
at any time, also if the appliance is off.
1. Press
again and again until
00 flash in the display.
2. Press + or - to set the Minute Minder. At
first the time is calculated in minutes
and seconds. When the time you set is
longer than 60 minutes, the symbol
comes on in the display. The appliance
then calculates the time in hours and
minutes.

Using the accessories

Warning! Refer to the Safety chapters.
Core temperature sensor
The core temperature sensor measures the
core temperature of the meat. When the
meat is at the set temperature, the appli-
ance deactivates.
There are two temperatures to be set:
• The oven temperature.
• The core temperature. Refer to the values
in the table.
Recommended core temperatures
50 °C
60 °C
70 °C
Important! Only use the core temperature
sensor supplied with the appliance, or
genuine replacement parts.
while setting the time
, the appliance
function.
and
Rare
Medium
Well done
3. The Minute Minder starts automatically
after five seconds.
4. When the set time ends, the acoustic
signal sounds for two minutes. 00:00
and flash in the display. Press a but-
ton to stop the signal.
If you set the Minute Minder when the
Duration or End
ates, the symbol
Count Up Timer
Use the Count Up Timer to monitor how
long the oven operates.
Press again and again until the display
shows time without clock symbols.
You cannot use the Count Up Timer
when the Duration
tion operates.
1. Set the oven function and the oven tem-
perature.
2. Put the tip of the core temperature sen-
sor into the centre of the meat.
3. Put the plug of the core temperature
sensor into the socket on the side wall
of the oven.
The display shows the symbol of the
core temperature sensor
default core temperature. When you
use the core temperature sensor for the
first time, the default core temperature
is 60 °C.
4. While
flashes, you can use the knob
for the temperature to change the de-
fault core temperature.
function oper-
comes on in the display.
or End func-
and the
12