Using The Accessories - IKEA SMAKSAK Bedienungsanleitung

ENGLISH
Setting the END function
1. Set a heating function. Press
confirm.
2. Press again and again until
to flash.
3. Turn the control knob to set the hours
and press to confirm. Turn the control
knob to set the minutes and press
confirm.
At the set End time the signal sounds for 2
minutes. and time setting flash in the
display. The oven turns off automatically.
4. Press any button or open the oven door
to stop the signal.
5. Turn the knob for the heating functions
to the off position.
This function is not available for Pyrolysis
and for some oven functions.
Setting the TIME DELAY function
1. Set a heating function. Press
confirm.
2. Press again and again until
to flash.
3. Turn the control knob to set the minutes
for DURATION time and press
confirm. Turn the control knob to set the
hours for DURATION time and press
to confirm.
The display shows flashing
4. Turn the control knob to set the hours
for END time and press
Turn the control knob to set the minutes
for END time and press
The display shows
temperature.
Oven turns on automatically later on, works
for the set DURATION time and stops at the
set END time.

Using the accessories

Warning! Refer to Safety
chapters.
to
starts
to
to
starts
to
.
to confirm.
to confirm.
and the set
At the set END time the signal sounds for 2
minutes. and time setting flash in the
display. The oven turns off.
5. Press any button or open the oven door
to stop the signal.
6. Turn the knob for the heating functions
to the off position.
You can change the heating function and the
temperature after you set the TIME DELAY
function.
Turn the knobs to the off positions to stop
the TIME DELAY function.
Setting the MINUTE MINDER
Minute minder can be both set when the
oven is turned on and off.
1. Press again and again until
to flash.
2. Turn the control knob to set the seconds
and than the minutes.
• Press one more time to set the
minutes
• Press two more times to set the
hours
3. Press to confirm.
4. The MINUTE MINDER starts automatically
after 5 seconds.
After 90% of the set time the signal
sounds.
5. When the set time ends the signal
sounds for 2 minutes. "00:00" and
flash in the display. Press any button to
stop the signal.
COUNT UP TIMER
Press again and again until the display
shows time without any symbols.
Inserting the accessories
Wire shelf:
15
starts