Operation; Stand-Alone Mode; Internal Programs; Dmx Mode - EuroLite LED LP-15 Bedienungsanleitung

The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the spot to the mains, the EUROLITE LED LP-15 Logo-Projector starts running.
The LED screen lights up and you can choose the desired settings.
The device has two operating modes. It can be operated in Stand-Alone or in DMX-controlled mode.

- STAND-ALONE MODE

- Automatic MODE

- DMX MODE

STAND-ALONE MODE
In stand-alone mode, the LED LP-15 Logo-Projector can be used without a controller. Disconnect the LED
LP-15 Logo-Projector from the controller.
LED Screen
The LED screen offers several features: you can run the internal programs or set the starting address.
Browse through the main menu by pressing the MODE button.
You can change the selection by pressing UP or DOWN.
The functions provided are described in the following sections.
The display shuts off after 10 seconds of inactivity. With the touch of a button it lights up again.

Internal Programs

Press the MODE button to select the internal program mode. When the LED screen shows P, you can select
the desired internal program, with or without sound control, via the UP or DOWN buttons (see following
graphic).
Mode:
P
DMX MODE
The LED screen allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED LP-15 Logo-Projector will respond to the controller.

Addressing

Press the MODE button until the LED screen shows „512". You can now set the desired address via the UP
or DOWN buttons.
Setting the DMX Start Address:
Mode:
512 d 1 – d512
Value:
Gobo rotating fast
P1
Gobo rotating middle
P2
Gobo rotating slow
P3
Gobo rotating static
P4
Value:
Function:
20/22 00064744.DOC, Version 1.0