Description Of The Device; Features; Overview; Installation - EuroLite LED LP-15 Bedienungsanleitung

DESCRIPTION OF THE DEVICE

Features

• Operable in stand-alone mode or via DMX • DMX512 control possible via any commercial DMX controller
(occupies max. 2 channels) • 2 DMX channels selectable for numerous applications • Comfortable
addressing and setting via control panel with LED screen and three operating buttons, • Functions: 4 internal
programs in auto mode, dimmer and gobo rotating speed via DMX, Master/Slave • Equipped with 1 x 15 W
LED • Beam angle approximately 26° • Floor, ceiling or trussing installation possible • Locking possibility at
the mounting bracket • 5 different gobos included in delivery

Overview

(1) Floor-stand/mounting bracket
(2) DMX-OUT
(3) DMX-IN
(4) Fixation screw
(5) Safety rope
(6) Power supply
(7) Fuse
(8) Manual focus
(9) LED-screen with operating buttons (Mode,
Up, Down)

INSTALLATION

Inserting/Exchanging gobos

If you wish to use other forms and patterns, or if gobos are to be exchanged, please follow the instructions
below:
Unscrew the fixation screws on the housing bottom and remove the top of the gobo housing. The gobo is
located in the toothring.
Remove the fixation-ring with an appropriate tool. Remove the gobo and insert the new gobo. Press the
fixation-ring together and insert it in front of the gobo.
Replace the housing top and tighten the screws.
The LED LP-15 Logo-Projector can be installed on the ground or on the wall or ceiling.
1
2
3
4
5
6
7
DANGER!
Install the gobos with the device switched off only.
Unplug from mains before!
16/22
1: Ground
2: Signal (-)
3: Signal (+)
DMX OUT
DMX IN
Safety rope
Power supply: 230 V AC, 50 Hz ~
Fuse: F 1 A, 250 V
00064744.DOC, Version 1.0
8
Mode Up Down
9