Display Setup; Record Setup - SKYTRONIC 351.142 Gebrauchsanleitung

5.3 Main Menu
Picture 5-2

5.3.1 Display setup

Picture 5-3
Picture 5-4
Picture 5-5

5.3.2 Record setup

Click [Main Menu] [Record] to enter into [Record Setup] menu (Shown as Picture 5-6).
[Record] option allows you set up record status (Enable/Disable) of each channel.

 [Bit rate] include three options – Best, Good and Normal.
Pack Time : indicates max continuous rec. time (15, 30, 45 and 60minutes)

After clicking right button of mouse, pop-up menu will be displayed
on the screen. You can click [main menu] button on pop-up menu
to enter into Main menu interface (Shown as Picture 5-2). In Main
Menu mode, you can control device management settings, such as
Display, Recording, Network, Recording search, Device and
System settings etc.
Go to [Main Menu  Camera] to set up the name display and
position display of each channel CH (Shown as Picture 5-3),
You can also adjust image brightness, saturation, contrast and
hue settings of each channel after entering into [Color] Menu
and set up whether each channel can be previewed or not
under Live display and/or Recording mode.
Please note that the name of each channel supports up to eight
characters.
Copy : This function allows you to copy all data of one channel
to any other channel.
The Color Menu, where you can adjust image brightness,
saturation, contrast
channel.(shown as picture 5-4)
The modifications will be available after clicking [APPLY] button on the bottom
of the sub-menu windows and being prompted to save and then clicking [ok]
button.
If you want to cancel the modification, click [Exit] button to exit the menu.
When clicking [DEFAULT] button, all system default values will be reset to
default value.
System default value indicates the value pre-set at the factory.
and hue parameters of each