Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Speed controller connections
1. First, you must connect the controller on the throttle channel (normally channel 1) of the receiver and connect the motor cable to the
correct polarity on the motor. Then check again to see that all the cables are connected properly. Only then connect the drive battery on the
controller and set the on/off switch to "ON".
2. The motor will not start running without the signal from the transmitter.
Assembly in the model
•
Mount the motor with the appropriate screws on the motor holder. Only screws of a suitable length must be used. Using screws that are
too long can damage the motor.
•
The speed controller must be mounted in the model in such a way that the cooling area largely remains unobstructed.
The speed controller and motor must be supplied with adequate cooling.
•
Please pay attention again to the correct cabling of the motor.
Initial operation of the speed controller
1. Switch on the transmitter and check the path of the throttle channel, which should be 100% in both directions.
(With multiplex RC systems, this must be 80%.)
The throttle must be in the "Motor off" position! The neutral position and the throttle positions of the speed controller are pre-programmed
and may only be changed via the transmitter by readjusting the trim positions/lever and the servo travel.
2. Connect the drive battery with the correct polarity to the speed controller.
3. Now switch on the speed controller.
4. The speed controller is now ready to use and all set for its first trip.
5. To move forwards, push the throttle stick of your remote forwards. To move backwards, pull it back. If this does not apply because the
function is reversed, you must reset the reverse switch of the throttle channel.
6. After use, first the speed controller must be switched off and then the drive battery connector detached from the speed controller.
Warning!
•
if the speed controller is switched on, you must pay attention to the motor and speed controller. Do not touch the motor shaft, ship's
propeller and rotating parts. There is a risk of injury in doing so. Ensure that the motor shaft is not blocked and does not drag.
•
Always switch the controller off after use and do not leave your model unattended.
•
Ensure that all the connections and cables are correctly routed and connected.
•
Avoid connecting incorrectly, short circuiting and reversing polarity.
•
Keep out of the reach of children.
•
Do not expose the unit to direct sunlight.
•
The speed controller has a temperature sensor to protect it from overheating. A good supply of cool air must be ensured; otherwise,
the controller will switch off.
•
Motor and controller heat up during operation. Please allow the components to cool down before storing or reusing.
CARSON RC Premium Boat Grand Captain 500106002
G
21
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
