Assembling The Boat Stand - Carson Grand Captain Betriebsanleitung

Never subject the battery charger, the batte-
ries and the model to adverse local conditions!
These are for instance:
• Wetness, too high air humidity (> 75% rel., condensing). Do not
touch the battery charger with wet hands.
• Never operate the battery charger right after it has been brought
from cold into warm surroundings. The resulting condensation
G
water can destroy the device. Permit the device to attain the
ambient temperature while unconnected.
• Dust and inflammable gases, vapours or solvents, benzene
• Too high ambient temperatures (> about +40°C), direct solar
radiation
• Open fire, ignition sources
• Mechanical stresses such as shocks, vibrations
• Strong contamination
• Strong electromagnetic fields (motors or transformers) or
electrostatic fields (charges)
• Transmitters (radio telephones, transmitters for model building
etc.). The transmitter radiation can lead to the malfunction of the
charging operation or to the destruction of the battery charger and
thereby also of the batteries.
Advice
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are only to be charged under adult
supervision.
• Batteries are to be inserted with the correct polarity.

Assembling the boat stand

18 CARSON RC Premium Boat Grand Captain 500106002
Permit the battery charger to cool down
between charging operations. Disconnect the
battery charger from the power when the
charging operation is finished.
A defective battery charger may no longer be employed.
If it is assumed that the device is defective, i.e. if
• The device shows visible damage,
• The device no longer works and
• After longer storage under unfavourable conditions or
• After severe transportation stress, then it should be made
inoperative without delay and secured against unintentional
operation.
Dispose of the unusable (irreparable) battery charger according to the
prevailing statutory regulations.
For safety and registration reasons (CE), the arbitrary reconstruction
and/or modification of the battery charger is not permitted.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• Regular examination of transformer or battery charger for any
damage to their cord, plug, enclosure and other parts.
Assemble the 4 parts of the boat stand as shown in the diagram.
Ensure that the lettering faces outwards. Then glue the parts together
using superglue at the points marked with an arrow. Fix the parts in
position on a table or similar flat surface so that the boat stand rests
on it evenly.