Assembling The Rc Unit - Carson Grand Captain Betriebsanleitung

Assembling the RC unit

2.4 GHz DSSS Digital Proportional Radio Control System
An appropriate RC unit must
be in service before you can
take your new model boat onto
the water. We recommend our
2.4 GHz transmitter tray unit
CARSON REFLEX STICK 6 Channel
Article no.: 500500001 which has
been used here as an example
in the following steps. You can
achieve a maximum range of
approx. 100 metres with the
REFLEX STICK 6 Channel.
Place your model boat on the pre-assembled boat stand (adhesive completely cured) and stay well clear of the propellers at all times. Carefully
remove the model's cover and have your receiver, RC unit and a fully charged driving battery ready. Now insert the receiver plug of the MARINE
speed controller into the throttle channel connection on the receiver. For the REFLEX STICK, the plug must be inserted into channel 1. Insert the
plug of the steering servo into the connection for channel 2 (for REFLEX STICK) on the receiver. For further information, refer to the Operating
Instructions supplied with your remote control.
Pay attention also to the notes and information included in the instructions supplied for the speed controller.
Connect the speed controller, motor, receiver and battery as shown in the diagram below:
to the battery
on/off switch
APPROX. 100 M RANGE
Art. no.: 500500001
black
to the receiver
(Channel 1)
CARSON RC Premium Boat Grand Captain 500106002
red
steering servo
(Channel 2)
electric motor
G
19