Operation; Sound Control; Dmx-Controlled Operation - EuroLite 51913600 Bedienungsanleitung

Ω
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120 resistor
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

OPERATION

After you connected the spot to the mains, the EUROLITE LED PAR-38 RGB Spot starts running.

Sound Control

In order to select Sound Control, first set dipswitch 10 to ON and dipswitch 9 to OFF. Sensitivity can be
adjusted with the rotary-control.
Manual Mode
To select Manual Mode set dipswitches 8, 9 and 10 to ON.
Dipswitch 1 and 2 control the brightness of the „R" LEDs.
Dipswitch 3 and 4 control the brightness of the „G" LEDs.
Dipswitch 5 and 6 control the brightness of the „B" LEDs.
Auto-Mix Color Mode
In order to select Auto-Mix Color Mode, set dipswitches 9 and 10 to ON and dipswitch 8 to OFF.
Speed (increasing) can be controlled by setting the dipswitches 1 - 7 to ON.

DMX-CONTROLLED OPERATION

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
18/37 51913600_V_1_1.DOC