Tools Needed For The Assembly; Your 2 Channel Radio System - Carson CRT Betriebsanleitung

Tools needed for the assembly

GB
Modelling knife 74053
Philips screwdriver
(small and big)
1,5/ 2 / 2,5 mm 74023

Your 2 channel radio system

Please read the instructions provided with your radio system
before using it.
The servos must be set at the centre position before
installation. To set the servos at a neutral position, turn on
the transmitter and receiver. Set the trim levers in the center
position and turn off the receiver, and then the transmitter. The
servos will be in proper neutral position for installation.
Receiver
Batteries for
receiver
6 V
0 0
3 0
Steering servo
6 CRT CARSON Race Truck 304007
011742_anl_304007_crt.indd 6 011742_anl_304007_crt.indd 6
Instant adhesive 53339
Hexagonal wrench 13118
Receiver antenna
Switch
Engine throttle
servo
Needle nose pliers 74034
Tool kit 908046
Transmitter
Scissors 13305
Side cutter 74035
Transmitter antenna
17.01.2008 13:22:01 Uhr 17.01.2008 13:22:01 Uhr