Tools Needed For The Assembly - Carson X10N Onroad Chassis Betriebsanleitung

Tools Needed for the Assembly

Modelling knife 300074053
Philips screwdriver
(small and big) 1,5/ 2 /
2,5 mm 300074023
Your Radio System (only for RTR version)
using it.
The servos must be set at the centre position before installation. To
set the servos at a neutral position, turn on the transmitter and recei-
ver. Set the trim levers in the centre position and turn off the receiver,
and then the transmitter. The servos will be in proper neutral position
for installation.
Receiver antenna
Instant adhesive 300053339
Hexagonal wrench 500905065
Switch
Steering servo
Engine
throttle servo
Needle nose pliers 300074034
Tweezers 300074003
CARSON X10N Chassis
Scissors 500013305
Side cutter 300074035
Transmitter
17
G