Herunterladen Inhalt Inhalt Diese Seite drucken

Ventus W155 Handbuch Seite 9

Vorschau ausblenden Andere Handbücher für W155:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 18
C/F
Toggle degree C & F unit
CONNECTING WITH REMOTE SENSORS
The weather station uses 433MHz radio signals to send and receive weather data between the
monitors and remote sensors.
After battery/adapter installation, the monitor will automatically search for remote sensors.
You can also enforce a searching mode by holding "CHANNEL/SEARCH" on the monitor.
Follow the instruction in the "INSTALLATION" section to set up the sensors and wireless connection. If
the connection cannot be established, reset the remote sensor by removing the batteries from the
sensor. Wait for 10 seconds and reinstall the batteries. Then hold "CHANNEL/SEARCH" on the monitor
to search for the sensors. If that continues to fail, shorten the distance between the sensor & monitor
and reinstall the sensors if necessary (Details refer "INSTALLATION" section)
NOTE: Whenever the radio-controlled icon
is flashing on the display, the weather station is
receiving radio-controlled clock signal and the RF reception for remote sensors will stop temporary for
around 8 minutes. Wait until this icon stops flashing (or disappear) before searching for the remote
sensors again by holding the "CHANNEL/SEARCH" button on the monitor for 3 seconds.
Anemometer (with built-in temperature & humidity sensor):
Important: Wind direction calibration is needed whenever the anemometer is reset (or during battery
replacement)
Searching mode display:
Wind direction, temperature & humidity information will flash
RF Connection completed:
Valid wind speed/direction & Ch-1 temperature/humidity readings appear
(It may take up to 10 minutes to receive all wind speed/direction & Ch-1 temperature/humidity readings
during the searching mode)
RF Connection failed:
"- - - -" wind speed appears; no wind direction. Unable to display Ch-1 temperature & humidity
Rain Gauge:
Searching mode display:
Total rainfall information will flash
RF connection completed:
Valid total rainfall reading appears
RF connection failed:
"- - - -" stops flashing & stays on the total rainfall display (previous daily/weekly/monthly rainfall readings
remain in record)
8

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis