Ventus W155 Handbuch Seite 15

- Using "▲"or "▼" to adjust and "CLOCK" to confirm, the following values can be set in sequence:
12/24hr format > Hr > Min > Yr > D/M or M/D format > Month > Date > EXIT
HOME TIME, WORLD (ZONE) TIME
Hold "ZONE" to enter world (zone) time setting mode. Press "▲"or "▼" to enter the desired hour offset
value from –12 to +12 hours. Press "ZONE" to confirm each setting.
Press "ZONE" button to toggle between home (radio-controlled) time and world (zone) time. "ZONE"
icon appears when world (zone) time is selected. When zone time is not used, set zone time to "0".
ALARM SETTING
Press "ALARM" button to show alarm time and the "ALARM" icon will appear. Press again to enable or
disable the alarm. Bell icon " " appears when alarm is enabled.
Hold "ALARM" to enter alarm time setting mode. Press "▲"or " ▼" to enter the desired Hour/ Min
values and press "ALARM" to confirm setting.
SNOOZE & BACKLIGHT
When alarm is going off, press SNOOZE/ LIGHT to trigger snooze function and "Zz" icon will appear. To
stop alarm for one day, press "ALARM" key.
In normal display, press SNOOZE/LIGHT for an extended backlight if adapter is not connected.
LOW BATTERY INDICATION
Low battery indication is available for the monitor itself and all of the remote sensors. Replace the
batteries and follow the setup procedure in this instruction manual.
Important: Wind direction calibration is required for the anemometer during battery replacement
(Details refer "Calibrating the anemometer & installing batteries" section)
BATTERY DISPOSAL
Replace only with the same or equivalent type recommended by the manufacturer.
Please disposal of old, defective batteries in an environmentally friendly manner in accordance with the
relevant legislation.
IMPORTANT NOTE:
Warning! The weather station and the outside sensor contain sensitive electronic components. Radio
waves transmitted e.g. from mobile telephones, walkie talkies, radios, WiFi, remote controls or
microwaves may influence the transmission distance of the weather station and the outside sensor and
lead to a shorter reception range. It is therefore important to keep as great distance as possible
between the devices of the weather station and the outside sensor and the devices which send out
14