Closing The Door; Replacing The Lamp - AEG S83600CSW1 Benutzerinformation

Problem
The temperature in
the appliance is too
high.
The temperature in
the refrigeration is
too high.
The temperature in
the freezer is too
high.
The appliance does
not operate.
The lamp does not
work.
"dEMo" appears on
the display.
In case the advice does not lead to re-
sults, call the nearest brand-mark service

7.1 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
Possible cause
The temperature in the
refrigerator is too low.
The door is not closed
correctly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
The appliance is switched
off.
The mains plug is not
connected to the mains
socket correctly.
The appliance has no
power. There is no volt-
age in the mains socket.
The lamp is in stand-by.
The appliance is in dem-
onstration mode.

7.2 Replacing the lamp

The appliance is equipped with a long-
life LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service
Center .
ENGLISH
Solution
Set a higher temperature.
Refer to "Closing the
door".
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Store less products at the
same time.
Make sure that there is
cold air circulation in the
appliance.
Store products so that
there is cold air circulation.
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electri-
cal appliance to the mains
socket. Contact a qualified
electrician.
Close and open the door.
Keep pressed approxi-
mately 10 sec the OK but-
ton since a long sound of
buzzer is heard and the
display shut off for a short
while: appliance start
works regularly.
35