Replacing One Type Of Exhaust Filter With Another; Maintenance Indicator With Reset Button; Inserting Batteries Into The Led Handle; When To Change The Thread Lifters - Miele 10 374 000/01 Gebrauchsanweisung

en
Replacing one type of exhaust filter
with another (dia. 33)
Do not use more than one exhaust fil-
ter at a time.
Your vacuum cleaner is fitted as stand-
ard with a type c AirClean Plus exhaust
filter.
You can however use one of the follow-
ing exhaust filters:
a AirClean
b Active AirClean 50 (black)
c AirClean Plus 50 (light blue)
d HEPA AirClean 50 (white)
When using the AirClean filter please
note (dia. 34)
An AirClean exhaust filter is supplied
with every packet of Miele dustbags. If
you wish to use this filter it is essential
that you use a filter grille (see "Optional
accessories").
Maintenance indicator with reset but-
ton (dia. 35)
The indicator lights up after approx. 50
hours of operation, which is equivalent
to about a year of average use.The level
of soiling of the dust compartment filter
and the exhaust filter must be checked
at this point.
The indicator will need to be reset each
time these items are replaced. The va-
cuum cleaner must be switched off to
do this.
 Press the reset button.
The maintenance indicator will go out
and reset to zero.
48
The indicator can only be reset by
pressing the reset button after the
light has come on. Pressing the but-
ton at any other time will have no ef-
fect.
Inserting batteries into the LED
handle (dia. 09 + 10)
You will need three 1.5 V (AAA) batter-
ies.
 Loosen the screws on the cover.
 Press down on both sides of the
cover to remove it.
 Take out the battery holder and in-
sert the three batteries supplied
making sure the polarity is correct.
 Replace the battery holder. Make
sure the arrows on the holder and in
the battery compartment line up in
the same direction.
 Replace the cover and tighten the
screws.

When to change the thread lifters

(not possible on EcoTeQ Plus floor-
heads)
The thread lifters on the suction inlet to
the floorhead can be replaced. Check
them from time to time and replace
them if the pile has worn down.

How to replace the thread lifters

(dia. 36)
 Use a suitable screwdriver to remove
the thread lifters from the slots.
 Fit new thread lifters.