en
Press the foot control.
If the suction power of the floorhead
seems too high, reduce the suction
until the floorhead is easier to man-
oeuvre (see "Use - To regulate the
suction power").
Using the SRD hard floorbrush
Please observe the flooring manu-
facturer's cleaning and care instruc-
tions.
This hard floorbrush is especially suit-
able for vacuuming floors with deep
gaps and crevices, e.g. old wooden
flooring.
Inserting batteries into the LED
handle (dia. 09 + 10)
Loosen the screws on the cover.
Press down on both sides of the
cover to remove it.
Take out the battery holder and in-
sert the three batteries supplied
making sure the polarity is correct.
Replace the battery holder. Make
sure the arrows on the holder and in
the battery compartment line up in
the same direction.
Replace the cover and tighten the
screws.
To activate the exhaust filter change
indicator
The exhaust filter change indicator
shows the remaining functional life of
the exhaust filter.
42
Press the release catch for the dust
compartment lid and raise the lid as
far as it will go (dia. 11).
Remove the indicator strip (dia. 12).
Press the exhaust filter change indic-
ator (dia. 13).
After approx. 10 - 15 seconds a thin red
line will appear in the left hand side of
the display (dia. 14).
Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.
The exhaust filter change indicator
shows the remaining functional life of
the exhaust filter. After approx. 50 oper-
ating hours, or approx. one year of av-
erage use, the display will be com-
pletely filled with red (dia. 15).
Using the accessories supplied
(dia. 16)
Crevice nozzle
For cleaning in folds, crevices or
corners.
Dusting brush with natural
bristles (only available in selected
countries)
For cleaning skirting boards, or-
nate and carved objects. The
head can be swivelled to adjust
the angle.
Upholstery nozzle
For cleaning upholstery, mat-
tresses, cushions, curtains, covers
etc.