Faytech 8 Inch Bedienungsanleitung Seite 49

The Draw Test function is used for accuracy and performance checking. Press this button and
a new pop up window will be popped up on the monitor (see below). Touch or drag your touch
pen or finger on this grid to gauge the effectiveness of the settings and calibrations that you
have made. If you are using your finger, you may have to press firmly to draw continuous lines.
Press the Clear button to clear the window. Press the Quit button to terminate this draw test.
4. Display-Multi-MonitorSetting tab:
If you selected "Support Multi-Monitor System" when you installed the Touch driver, you will
see a Display tab when you run the Touchkit Configure utility. If you did not select this option,
you will not see a Display tab.
You can have up to four faytech touch-screens connected simultaneously. You can also use a
(non-touch) display and a touch screen. In the example below, the touch-screen is display "1",
while the second display "2" is a normal monitor. Both have the same resolution, but the touch
screen is the primary monitor.
Enable multiple-monitors: When this function is disabled, the touch screen will be mapped to
the primary monitor automatically. When this function is enabled, you can double click on the
monitor area in the monitor geometry window to assign the monitor area where the touch
49