Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Display Connection
Each cable is labeled for easy connection. To operate your faytech display properly, there
must be at least one signal source and a power source connected. To use the touch function
please connect the USB cable to your PC.
TO CONNECT THE SIGNAL SOURCE,
you have the following options:
On a PC: Connect the VGA cable from the faytech monitor to the VGA output of your PC
graphics card. Please select SOURCE VGA, so you have an image on the display.
On a PC: If you have a HDMI/DVI output on your PC please use the HDMI-port of the
faytech touch-monitor, with DVI you need a DVI to HDMI connector. Please change
SOURCE to HDMI.
To DVD-Player/camera/Video source: Connect one or two video inputs (labeled Video or
SVideo) to a corresponding video source. Please be sure to switch off the video source
before you connect the cables. Switch SOURCE to the respective channel input (AV or
SV).
In addition, the display has two stereo audio inputs, one for the PC (3.5mm Audio-In) and one
for the two video inputs (sound is carried on both channels), a white and red RCA connector,
white AUDIO-Left and red AUDIO-Right. Audio comes through the speakers only if there is an
image signal. Audio is also available from the earphone output on the front side of the display.
If earphones are connected, the built-in speakers will not be active.
Tip: You can use the display simultaneously with all five video signal sources. Use the
SOURCE button on the display or remote control to switch between the various signal
inputs.
CONNECT TO POW ER
You can connect the faytech display with the included 120V/220V plug or the 12V power
adapter. Insert one of these power sources into the 12-36V DC-IN.
Another alternative is to connect another 12-36V source to the DC-IN. Please pay attention not
to mix the polarity (+ is inside)! Please make secure that the power source has enough current,
at 12V 1.5A.
USING THE TOUCH FUNCTION
37
Werbung
Inhaltsverzeichnis
