Faytech FT07TMB Bedienungsanleitung Seite 49

Enable multiple-monitors: When this function is disabled, the touch screen will be mapped to
the primary monitor automatically. When this function is enabled, you can double click on the
monitor area in the monitor geometry window to assign the monitor area where the touch
screen will be mapped. Double-tap on the desired monitor and answer the question in the
pop-up window with Yes.
After confirmation, your touches on the selected touch monitor will be simulated as mouse
clicks.
If the function "The touch sensor is automatically connected to the main system" is
activated, the program automatically puts the touch function on the primary monitor, if only one
monitor is connected.
The Operation mode settings allow you to set the size of the touch area on your faytech
touch-screen. E.g. if you select the "right screen", after a new calibration only the right side of
the monitor will work as a touch area. If you select "other" and then click on the ->> button, you
can set more modes or set an individually touch-defined area.
10. Edge Compensation tab: fine adjustment of the touch area
49